Review
Goodman builds mid-market HVAC equipment that balances affordability with respectable performance. This 2-ton system combines an 80,000 BTU gas furnace with a matching air conditioning unit, making it a straightforward all-in-one replacement. It's designed for homes roughly 1,200 to 1,500 square feet where previous systems operated at the same tonnage. The downflow configuration offers flexible installation in attics or utility closets, while the A-coil design integrates easily with existing ductwork.
The 92% AFUE rating means the furnace converts 92 cents of every heating dollar into warmth, a strong baseline for gas equipment. On the cooling side, the 14 SEER efficiency delivers 24,000 BTU of cooling capacity, positioning it above minimum standards but below premium units reaching 16 SEER or higher. The multi-speed blower motor adjusts between 1,200 and 1,600 CFM depending on heating or cooling demand, improving comfort during partial-load conditions. R410A refrigerant is industry standard and widely serviced.
Pros & Cons
Pros
- 92% AFUE furnace converts nearly all fuel to usable heat, reducing winter utility bills significantly
- 14 SEER cooling efficiency exceeds minimum standards and qualifies for many regional rebate programs
- Multi-speed blower motor allows variable airflow, improving comfort and reducing energy waste during partial-load operation
- Compact 26 inch width and 27.5 inch height fit tight spaces where full-size units won't work
- Single-stage operation keeps initial cost lower while maintaining adequate performance for most residential applications
Cons
- Not Energy Star certified, so it misses the highest efficiency tier despite respectable 14 SEER rating
- Single-stage compressor cycles on and off rather than modulating, creating minor temperature swings
- 71 decibel noise level during operation is audible, particularly in quiet neighborhoods or bedroom installations
Who Should Buy
Best For
Homeowners with 2-ton cooling loads in HVAC zones 3-5 who prioritize cost-effectiveness over cutting-edge efficiency. Contractors installing replacement systems in smaller homes where this tonnage matches existing ductwork and load calculations.
Consider Alternatives If
Buyers in extremely hot climates needing maximum cooling capacity, or those pursuing premium efficiency rebates requiring SEER 16 or higher ratings.
Installation
Installation requires standard 208/230V single-phase electrical service with a 14.3 to 25 amp breaker, typical for most residential panels. The PVC exhaust flue vents through the right side, requiring proper slope away from the unit. Suction line uses 3/4 inch diameter copper with 3/4 inch foam insulation, supplied in 50-foot lengths. Pre-installed A-coil simplifies indoor unit setup, though licensed HVAC technicians should handle refrigerant work.
Warranty & Reliability
Goodman provides a 10-year parts and labor warranty when you register the unit online within 30 days of installation. This covers compressor, heat exchanger, and all major components, offering solid mid-range protection. Registration is straightforward and required to activate full coverage, so don't skip this step after installation.
Specifications
| SKU | LS38343850 |
| Brand/Manufacturer | Online Supply |
| Cooling BTU | 24,000 |
| Heating BTU | 80,000 |
| Refrigerant | R410A |
| Electrical | 208 / 230 V. 1 Phase 60 Hz |
| Warranty | 10 Years with Online Registration |
| Decibel Level (dBA) | 71 |
| Weight (in lbs) | 22.000000 |
| Feature | Spec |
| Safety Information | PROPOSITION 65 WARNING This product and many products on our site may contain a chemical know to the state of California to cause cancer or birth defects or other reproductive harm. For more information about Proposition 65 please Click Here. |
| Airflow Direction | Downflow/Horizontal |
| Exhaust Flue Requirement | Plastic / PVC |
| Furnace Efficiency / AFUE | 92% |
| Blower Motor | Multi Speed |
| Maximum CFM | 1600 |
| Configuration | Upflow / Downflow |
| Flue Location | Right |
| Burner Stages | Single |
| Fuel Type | Gas |
| Height | 27.5" |
| Width | 26" |
| Depth | 26" |
| Resources | Goodman Installation Manual Goodman Specifications Goodman Brochure Goodman Warranty Information Goodman Service Instructions Goodman Kit Instructions Goodman Parts Manual You will need Adobe® Acrobat® Reader to view PDF documents. |
| Liquid Line | 3/8" |
| Suction Line | 3/4" |
| Tonnage | 2 Ton |
| Style | A-Coil |
| Energy Star | No |
| SEER1 (Efficiency) | 14 |
| Condenser Stages | Single Stage |
| Compressor Type | Rotary |
| Liquid Valve Size | 3/8" |
| Suction Valve Size | 3/4" |
| Max Breaker Size | 25 amps |
| Min. Breaker Size | 14.3 amps |
| Suction Line Insulation Thickness | 3/4" |
| Length | 50 feet |
Frequently Asked Questions
Affiliate disclosure: IndustrialRank earns a commission on qualifying purchases at no extra cost to you. We only recommend products we have independently reviewed.